Rev. 5/16/2014
CYL-H-4-KD, manual.doc
Copyright 2014 Vestil Manufacturing Co.
Page
5
of
8
Step 3 – Attach the shelves
a. The shelves are identical, so it does not matter which shelf is installed above and below.
b. Remove
the
5
/
16
in. hex nuts (11) and flat washers (10) from the bolts connecting the side panels to the
back plate.
c. Install a shelf in the lower position first. Insert the shelf into the assembly with cross supports pointing
upwards. Align the bolt holes in the shelf frame with the bolts in the lower bolts holes (of the back plate
and the side panels).
d. Reinstall the flat washers and hex nuts and tighten them.
e. Insert bolts through the lower bolt holes in the front sides of the side panels (shown below).
f. Install the second shelf in the same manner as shown in the diagram below.
Shelf weldment
Cross
support
Shelf
frame
Bolt
hole
5
/
16
in. – 18
x
3
/
4
in. bolt
5
/
16
in.
hex nut
5
/
16
in. – 18
flat washer
Step 5 – Attach top cap (1) to assembly
a. Set the top cap on top of the assembly with the
flanges overhanging the front and back sides.
b. Fasten the top cap to the assembly with 12 sets of
5
/
16
in. bolts, hex nuts, and flat washers as shown in
the diagram below.
Flange of
top cap
Top cap
Top cap
Flange
of top
cap
5
/
16
in. – 18
x
3
/
4
in. bolt
Step 4 – Attach door latch (3)
a. The cabinet can be configured to allow the
door to open to either the left or the right. In
the diagram below, the door latch is installed
through the latch slot in the left side panel to
allow the cabinet to open to the right.
b. Insert the latch through the latch slot from the
inside of the cabinet.
c. Insert the spring pin (14) through the pin hole
in the latch to secure it in place.
5
/
16
in. – 18
x
3
/
4
in. bolt
Door latch
Latch slot
Spring pin
Latch slot
in right
side panel
Pin
hole
Door groove
