Vestil AWST-3672-PU, Руководство пользователя

Страница: 4 / 5

Table of Contents Rev. 9/29/2020 AWST MANUAL
Table of Contents Copyright 2020 Vestil Manufacturing Corp. Page 4 of 5
USING THE TRUCK
Attach the tongue of the truck to the hitch of a tow vehicle. Center and evenly distribute loads on the
truck surface. Immobilize loads on, and strap loads to, the truck to prevent them from moving while the
truck is in motion. Do not attempt to transport unstable, top-heavy, very tall or very long items with the
truck. Start and stop slowly and gradually. Apply brakes carefully. Drive slowly through all turns. Only
drive on even, level, improved surfaces.
INSPECTIONS AND MAINTENANCE
Written Record — Before using the product for the first time, make a written record of its
appearance. Describe the condition of the frame, hardware, and mechanisms. Take photographs of
each feature and add them to the record. Take photographs of all labels applied to the product.
Describe where each label is located. This record establishes satisfactory condition .
Inspections and repairs should only be performed by qualified persons. Compare the results of
each inspection to the WRITTEN RECORD. Do not use the system unless all parts are in
satisfactory condition. Replace parts that are not in satisfactory condition before returning the
system to service. DON’T GUESS! If you have any questions about the condition of your
product, contact the TECHNICAL SERVICE department (see cover page of this manual). Never
make temporary repairs of damaged or missing parts . Only use manufacturer-approved replacement
parts.
Before each use — Perform the following inspections.
1. Check the surface of the product for dirt or other matter. Clean the surfaces.
2. Examine hardware & fasteners, including but not limited to bolts, nuts, and pins. Replace damaged,
worn, or corroded hardware.
3. Examine frame elements for wear, breakages, corrosion/rusting, damage, and metal fatigue.
4. Check all labels. Replace labels that are damaged or not easily readable.
5. Examine the whole structure for rusting/metal erosion, rot, thinned regions. If rusting is purely
superficial, remove the rust/corrosion with a steel bristle brush or steel wool. Clean the affected
area and apply touchup paint. If rusting, rot, or thinning has weakened the material, contact
TECHNICAL SERVICE for advice.
LABELING DIAGRAM
Label content and location are subject to change so your product might not be labeled exactly as
shown (below). Compare this labeling diagram to the RECORD . If actual labeling and/or label placement
differs from the diagram, contact TECHNICAL SERVICE to determine whether the labeling of your
product requires updating. During the lifetime of this gate system, replace all labels that are damaged,
missing, or not easily readable (e.g. faded). To order replacement labels, contact the TECHNICAL
SERVICE and parts department online at https://www.vestil.com/page-parts-request.php . Alternatively,
you may request replacement parts and/or service by calling (260) 665-7586 and asking the operator to
connect you to the Parts Dept
.
Label 287
658