Vestil AHA Series, Инструкция по эксплуатации

Страница: 17 / 24

Table of Contents Rev. 2/4/2021 AHA MANUAL
Table of Contents Copyright 2020 Vestil Manufacturing Corp. Page 17 of 24
ASSEMBLING THE CRANE
If the crane is improperly assembled, it might malfunction and result in serious personal injuries.
Read this instruction manual in its entirety before assembling the crane; only assemble the crane if you fully
understand both the associated risks and the manufacturer-approved assembly procedure discussed below.
• Follow the assembly procedure described in Steps 1-8. If you have any questions about the assembly process,
contact TECHNICAL SERVICE .
• ONLY qualified personnel should assemble the crane.
• DO NOT modify the crane in any way. Modifying the crane automatically voids the
LIMITED WARRANTY
on p. 24
and might make the crane unsafe to use.
• DO NOT use the crane if you notice damage to, or deformation of, the beam, uprights, or any part of the leg
assemblies. Using the crane despite weakness of a structural component could result in crane collapse.
•
DO NOT
use the crane if any of the hardware (bolts, nuts, clamps, etc.) is damaged or missing. Contact the
Replacement Parts Dept . to order replacement parts.
• DO NOT use the crane if any of the casters are damaged. A damaged caster may cause the crane to tip over, and
the possibility that the crane will tip increases while it is used to hoist or support a load.
UU
Step 1
UU
: (for 2,000 lb. (AHA-2-#-#) and 4,000 lb. (AHA-4-#-#) models only)
Insert the end of each leg into one of the leg openings in the yoke as shown below. Fasten the legs to the yoke with
clevis pins (33-112-034 or 28-112-031) and secure the clevis pins with hitch pins. Insert a knob into the yoke until the
end of the knob presses firmly against the leg.
Step 2: (for Come-Along accessory kit only) If you have a “Come-Along” kit used to adjust the height of the crane),
install the cable loops before inserting the uprights into the yokes. Twist the provided cable loops into a figure “8”; then
fold it over onto itself (this will double loop the cable). Slide the doubled loop around the receiver of the yoke.
¾ in. diameter clevis pin (33-
112-034 or028-112-031)
Leg weldment
Yoke
3
/
8
in. - 16 x 1¼ in. knob
Caster mount
bracket
Hitch pin
Hitch pin
opening
Slide doubled cable loop onto receiver of yoke.
Cable must wrap around yoke below both the
adjustment pin and threaded knob.
Upright
Receiver
NOTE: Instructions for using the Come-
Along kit are provided in a separate
document titled, AHA-KIT Height
Adjustment Kit Instruction Manual
available online at www.vestil.com/page-
manuals.php