Vestfrost FZ 277R, Инструкция по эксплуатации

Страница: 7 / 16

7
GB
The door can be changed from right-hinged to left-hinged and vice versa as follows:
Reversing the door
1. Lay the appliance on its back with the
door uppermost. 2. Remove the upper hinge.
3. Move the plastic plugs to where the
upper hinge was fi tted.
5. Remove the door closer and refi t it on
the opposite side. 6. Remove the kick plate by pulling it
outwards and upwards.
10. Refi t the door.
11. Keep the door closer to the left.
12. Fit the upper hinge.
7. Remove the screws holding the lower
hinge in place. Turn the pin on which the
door was mounted so that it points in the
opposite direction. Rotate the hinge
through 180° and refi t it on the opposite
side of the appliance.
13. Remove the door handle and refi t it on
the opposite side. Refi t the caps.
14. The appliance must be allowed to
stabilise in an upright position for at
least 1.5 hours before being switched on.
4. Lift off the door and lay it aside.
8. Refi t the kick plate
9. Adjust the lower hinge and tighten.
15. After reversing the door(s), it is important to check that the sealing strip provides a tight seal all the way round. If it does not, carefully
heat the strip all the way round using a hair dryer. Then ease the strip outwards slightly so that it forms a tight seal against the cabinet.
Be careful not to heat the strip so much that it melts!