Vestfrost CBI 2791 F NF E, Руководство пользователя

Страница: 21 / 52

EN
21
INSTALLATION INSTRUCTIONS AND DOOR
REVERSIBILITY
Installation instructions
! It is recommended that this installation be performed by authorized technical
stuff.
! Before installation, read the instructions carefully.
! Fit the refrigerator/freezer in stable kitchen units only.
! If necessary, reverse the door according to instructions.
1. See fig.A for the necessary attachment components.
2. Unscrew two screws at the top surface. (fig.E)
3. Open the package. Take gasket spacer
(9)
and brake into three as shown in
figureD. The middle part is
door hang rail
(10)
. The other two parts are
unit door
spacers
(11)
. (fig.D)
4. Peel the double sided tape at the bottom surface of trim flap
(1)
. Insert trim flap
(1)
into slot and screw by 2 screws(8) to left / right side. (fig.F)
IMPORTANT NOTICE: Do not screw any screw to the middle.
5. Pass the power cord through ventilation shaft and position it so that the
appliance could be easily plugged in once it has been installed. (fig.B - fig.C)
6. Cut trim gasket
(4)
to the height of the recess and stick it on reverse side of the
door hinges of the appliance. (fig.F)
7. Raise the appliance and slide into the kitchen unit.
8. Lean the appliance to the kitchen unit through the hinges and align the front
feet with front surface of the kitchen unit. (fig.G)
9. Open the appliance door and screw the front feet by using
screws
(7)
. (fig.H)
10. Screw trim flap
(1)
to kitchen unit using screws
(7)
. (fig.H)
11. Screw the hinges to the kitchen unit using screws
(7)
. (fig.H)
12. Close the appliance door. Unscrew and remove the nuts
(14)
, washers
(13)
and
adjustment bolts
(12)
from the appliance door. (fig.I)
13. Take out the liners of the tapes on door hang rails
(10)
. Place door hang rails
(10)
on the appliance door by inserting the bosses on the holes of the appliance
door, aligning the front surfaces of the door hang rails
(10)
and the appliance
door parallel to each other. Let the
door hang rails
(10)
, stick onto the appliance
door. (fig.I)
14. Slide the door hang
(2)
into door hang rails
(10)
. (fig.J – fig.K)
15. Take out the liners of the tapes on the front side of the
door hang
(2)
.
16. Take out the liners of the tapes on the
unit door spacers
(11)
and and stick
them onto the unit door
(15)
, closer to the upper corners. (fig.K)
17. Lean the
unit door
(15)
to the
door hang
(2)
, aligning the
unit door spacers
(11)
on the left, right and top edges with the sides of the unit or the doors of the
nearer and upper kitchen units. (fig.K)
18. The bumper
(9)
must stick to be located on the middle of the unit door
(15)
with
equal space. (fig.L)