•
They produce good results for certain types of usage only. If you are using this type of
detergents, you need to contact the manufacturers and find out about the suitable
conditions of use.
•
When the conditions of use of such products and the machine settings are appropriate,
they ensure savings in salt and/or rinse aid consumption.
•
Contact the detergent manufacturers if you are not obtaining good wash results (if your
dishes stay calcareous and wet) after having used 2 in 1 or 3 in 1 detergents. The scope of
warranty for your machine does not cover any complaints caused by the use of these types
of detergents.
Recommended usage:
If you want to obtain better results while using combined
detergents,
add salt and rinse aid into your machine and adjust the water hardness setting and the rinse aid
setting to the lowest position.
Solubility of the tablet detergents produced by different companies can vary
depending on the temperature and time. Therefore, it is not recommended to use
such detergents in short programs. It is more suitable to use powder detergents in such
programs.
Warning:
Should any problem, which you have not encountered before, arise with the use of
this type of detergents, contact the detergent manufacturers directly.
When you give up using combined detergents
•
Fill the salt and rinse aid compartments.
•
Adjust the water hardness setting to the highest position and run an empty-wash.
•
Adjust the water hardness level.
•
Make the suitable rinse aid setting.
20
1.1. Filling the rinse-aid and setting
To fill the rinse aid compartment, open the rinse-aid compartment cap. Fill the compartment
with rinse aid to the MAX level and then close the cap. Be careful not to overfill the rinse
aid compartment and wipe up any spills.
In order to change the rinse aid level, follow the below steps before turning on the
machine:
• Turn the knob to the “off” position.
• Push the “Start/Pause” button and hold it down.
• Turn the knob counter clockwise one step.
• Hold down the “Start/Pause” button until the LEDs flash and “rA” disappears.
• The machine will display the current setting.
• Set the level by pushing the “+” and “-” buttons.
• Turn the knob to the “off” position to save the setting.
The factory setting is “4”.
If the dishes are not drying properly or are spotted, increase the level. If blue stains form on
your dishes, decrease the level.
