8
POWER
SERIAL NO.
INPUT
C A U T I O N
41
38
39
35
36
33
34
43
42
41
40
37
#3
LINE INPUT JACKS
These jacks are used to connect line level output devices
to the PMC-007. Devices with a line level of -10dB to
0dB, such as CD players, MD players, tape decks, DAT
players etc may be connected to these jacks. The signal
from these devices will then be fed to the respective PGM
and Line Input is selected.
#4
PHONO INPUT JACKS
These jacks are used to connect turntables with moving
magnet type cartridges. Once connected, the signal from
the turntable will be fed to the respective PGM when
Phono input is selected.
#5
MIC JACK
Used for the connection of MIC inputs.
#6
EFFECT LOOP JACKS (MIC)
This jack is used to connect external effects that are fitted
with a 1/4 inch stereo plug. In order to produce the best
sound, please set your external effect unit such that the L
channel is Effect Send and the R channel is Effect Receive.
TIP:
………………
MIC SEND OUT
RING:
……………
MIC RECEIVE OUT
SLEEVE:
…………
EARTH
#7
GROUND TERMINAL
This connection point is used to ground turntables
connect to this unit.
#8
EFFECT SEND JACK
Used to connect the inputs of an external effects device.
#9
EFFECT RECEIVE JACK
Used to connect the output of an external effects device.
$0
BOOTH OUT JACK
Use these jacks to connect booth monitors to this unit.
This signal is identical to that of the headphone section
with the exception of when the Rehearsal Mute/Freeze
feature is active.
$1
MASTER OUT JACK (Balanced & Unbalanced)
These jacks may be used to connect this unit to an
amplifier. This unit has 2 sets of output jacks so that each
output level can be set separately. In this situation, the
Master (XLR) out can be used as the main output whilst
the 1/4 inch output can be used as a sub unbalanced output.
$2
POWER JACK
Connect the Vestax AC-12A, AC adaptor (12V AC,
1000mA).
$3
POWER SWITCH
Power on/off.
SEND
RECEIVE
GND
T.R.S JACK
REAR PANEL
