Vestamatic 01066291, Инструкция по установке и эксплуатации

Страница: 7 / 10

Subject to modifications. © Vestamatic GmbH
7/10
G
H O M E · VL-SMI-230-45
Art.-Nr.:
8900 001 GB 3117 A04 • Vestamatic GmbH • Dohrweg 27 • D-41066 Mönchengladbach
• www.vestamatic.com
Changing motor turning direction
– Hold down the button or to
check the motor turning direction.
– When the motor reacts in opposite direc-
tion (when motor goes down when you
press up and vice-versa), you need to
change the motor direction. Motor direc-
tion can only be changed during installa-
tion phase, when no limit positions are set.
– Press the button shortly.
– The red LED starts blinking as long
as the change motor turning direction
process is in progress.
– The red LED lit solid if the process
is finished.
UP
DOWN
red
Change turning
direction
green
yellow
Setting electronic limit position
ATTENTION!
– The motor starts to move with a short delay time during
installation phase, when no limit positions are set.
–
Conditions to use the physical (automatic) limit position
settings: The upper limit stop has to be installed.
Ä
Electronic limit position setting combination
ULP = is an abbreviation for U pper L imit P osition.
LLP = is an abbreviation for L ower L imit P osition.
Following combinations virtual / physical limit position settings are possible:
Both upper and lower limit
position are virtual.
Upper limit position is virtual,
lower limit position is physical.
Upper limit position is physical,
lower limit position is virtual.
Both upper and lower limit
position are physical.
UP
DOWN
red
Change turning
direction
green
yellow
Virtual – Virtual
Option: start with lower limit position setting
– Hold down the button to move the motor in the re-
quested lower limit position.
– Press the button shortly.
– The red LED of button starts blinking as long as the
limit setting process is in progress.
– The red LED of button lit solid if the process is
finished.
– Hold down the button to move the motor in the re-
quested upper limit position.
– Press the button shortly.
– The green LED of button starts blinking as long as
the limit setting process is in progress.
– The green LED of button lit solid if the process is
finished.
– The motor needs the following complete movement
(figure 1) to memorize the limit position. (Hold down the
button
to move the motor in the requested direction).
The motor will give a feedback (short up /down move ment)
to confirm that the installation procedure has ended.
Advice: start with upper limit position setting
– Hold down the button to move the motor in the re-
quested upper limit position.
– Press the button shortly.
– The green LED of button starts blinking as long as
the limit setting process is in progress.
– The green LED of button lit solid if the process is
finished.
– Hold down the button to move the motor in the re-
quested lower limit position.
– Press the button shortly.
– The red LED of button starts blinking as long as the
limit setting process is in progress.
– The red LED of button lit solid if the process is
finished.
– The motor will give a feedback (short up / down move-
ment) to confirm that the installation procedure has
ended.
figure 1