ZigBee Network Setup
ZigBee Device Guideline
ZigBee is a wireless communication protocol that is reliable and has low power consumption and high transmission
efficiency. Based on IEEE802.15.4 standard, ZigBee allows a large amount of devices to be included in a network and
coordinated for data exchange and signal transmission.
Due to the fundamental structure of ZigBee network, ZigBee device will actively seek and join network after powering on.
Since performing a task in connecting network may consume some power, it is required to follow the instructions to avoid
draining battery of a ZigBee device.
-
Ensure your ZigBee network router or coordinator is powered on before inserting battery into the ZigBee device.
-
Ensure the ZigBee network router or coordinator is powered on and within range while a ZigBee device is in use.
-
Do not remove a ZigBee device from the ZigBee network router or coordinator without removing the battery from a
ZigBee device.
Joining the ZigBee Network
As a ZigBee device, the Sensor needs to join a ZigBee network to transmit signal when it is triggered. Please follow the
steps bellow to join the Sensor into the ZigBee network.
1. Remove the insulator from the Sensor to power on.
2. After powering up, use sharp tools such as a paper clip to press and
hold the Function button for 10 seconds until LED
flash once, then release it to join the network. Please make sure the permit-join feature on the router or coordinator of
your ZigBee network is enabled.
3. If the Sensor successfully joins a ZigBee network, the LED Indicator will flash twice to confirm (refer to you Control
Panel to complete learning).
4. After joining the ZigBee network, the Sensor will be registered in the network automatically. Please check the ZigBee
coordinator, system control panel or CIE (Control and Indicating Equipment) to confirm if joining and registration is
successful.
5. After joining the ZigBee network, if the Sensor loses connection to current ZigBee network, the LED will flash every 20
minutes to indicate. Please check your ZigBee network condition and Sensor signal range to correct the situation.
Removing Device from ZigBee Network (Factory Reset)
To remove the Sensor from current ZigBee network, the Sensor must be put to Factory Reset to complete device removal.
Factory Reset function will clear the Sensor of its stored setting and information and prompt the Sensor to search for new
ZigBee network.
Before removing device, make sure the Sensor is within current ZigBee network signal range
1. Press and hold the function button for 10 seconds, then release the button to reset Sensor.
2. Upon reset, the Sensor will clear current ZigBee network setting and transmit signal to ZigBee coordinator to remove
itself from current ZigBee network. It will then actively search for available ZigBee network again and join the network
automatically.
Installation
The Sensor should be installed on a glass to detect shock/vibration or glass breakage. Use the double side adhesive tape
provided to secure the Sensor on the window.
Appendix
(For developers only)
Vibration Movement Sensor Cluster ID
Device ID: IAS Zone 0x402
Endpoint: 0x01
Server Side
Client Side
Mandatory
Basic (0x0000)
Basic (0x0000)
Identify(0x0003)
IAS Zone(0x0500)
Optional
None
None
Attribute of Basic Cluster Information
Identifier
Name
Type
Range
Access
Default
Mandatory /
Optional
0x0000
ZCLVersion
Unsigned 8-bit
integer
0x00 –0xff
Read only
0x01
M
