Vesta Pro 600 VAC, Руководство пользователя

Страница: 12 / 13

Trouble Shooting
Use the table below to solve minor UPS installation or operation
problems. If any abnormal situations occur that are not listed
above,please call service people immediately.
Symptom Possible Cause Remedy
No LCD display on
the front panel.
1. Missing battery. 1. Charge battery up to 8
hours.
2. Battery defect. 2. Replace with the same type
of battery.
3.When the Input cord
isn’t electvified and
Power switch is not
pressed.
3. Press the power switch
again or elecerity the Input
cord
Alarm buzzer
beeps continuously
when AC supply is
normal.
Overload of the UPS. Verify that the load matches
the UPS capability specified in
the specs.
When power
failure, back-up
time is shorten.
1. Overload of the UPS. 1. Remove some noncritical
load.
2. Battery voltage is too
low.
2. Charge battery 8 hours or
more.
3. Battery defect due to
high temperature
operation environment,
or improper operation
to battery.
3. Replace with the same type
of battery.
Communication
lost between UPS
and computer.
1. Software is not
installed well.
1. Check the setting of the
software .
2. Cable is not properly
connected.
2. Check the USB cable is
firmly connected to
COM1/COM2 of the
computer and confirm the
setting again.
Mains normal but
LCD display
Battery mode.
1. Fuse is blown. 1. Replace the same type of
fuse.
2. Power cord is loose. 2. Reconnect the power cord
properly.