2(8)
MicroSonde MPL6-33
The serial number of your device is indicated on your MicroSonde and on the
storage case. The serial number may wear off, enter the serial number below and
always refer to this information when you need to contact the manufacturer.
VERSION NUMBER
X31-A
SERIAL NUMBER
___________________________
IMPORTANT SAFETY INFORMATION
The following symbol is used throughout this manual mark important instructions.
Please take care when meeting this symbol:
GENERAL INFORMATION
The MicroSonde MPL6-33 is small battery-operated transmitter that emits a 33 kHz
signal, which can be located by a receiver operating on the same frequency. The
Sonde is intended to be used in non-conductive ducts, cavities and structures. The
device is intended for professional use.
ITEMS SUPPLIED
1 MicroSonde transmitter
MPL6-33
2 Lithium battery
BR425
1 Battery compartment with female M5 thread
MPL6-M5
1 Case with quick reference guide
SB4-6
BATTERY INSTALLATION, TURNING ON AND OFF
Figure 1: Inserting battery
Insert a BR425 battery. Observe polarity (Figure 1). To turn the MPL6-33 on, tighten
the battery compartment. The LED at the tip of the MicroSonde will start flashing.
Take care to fully tighten to avoid water getting into the device. To turn the Sonde
off, unscrew battery compartment. Always remove the battery completely when
you are not using the Sonde.
When the battery has insufficient capacity left for carrying out measurements, the
LED will turn off. Replace the battery. Low temperatures reduce the operating time
of the battery.
