7
V E R T U
T H E B A T T E R Y A N D S I M C A R D
T H E B A T T E R Y A N D S I M C A R D
If your Vertu phone was purchased at a Vertu
store, the battery and SIM card should have
been installed already. Otherwise, follow the
procedure below to install your SIM card and
battery.
The SIM card and its contacts are easily
damaged. Be careful when handling, inserting
or removing the card.
Caution. Keep SIM cards and the back cover
release key out of the reach of small children.
Always switch the phone off and disconnect
the charger before removing the battery.
Do not remove the release tab or the protective
plastic film from the battery as this will damage
the battery.
>
With the back of your Vertu phone facing
you, position the back cover release key (
01
)
very carefully into the slot of the locking
screw (
02
). Ensure the key does not slip out
of the slot.
>
Turn the locking screw (
02
) a quarter of a turn
anticlockwise, gently pivot (by no more than 45
degrees) and lift off the back cover (
03
)
towards you as shown. If you accidentally
remove the back cover while the phone is
switched on, the phone will automatically
switch off.
Attach the back cover release key to
your keyring for convenience.
>
Remove the plastic placeholder (
04
) from
your Vertu phone before inserting the
battery.
Retain the plastic placeholder for future
use. If you need to remove the battery,
insert the plastic placeholder before
replacing the back cover to make it
easier to remove the back cover.
>
Slide the SIM retainer (
05
) towards the
bottom of your Vertu phone and then pivot
outwards.
>
Insert the SIM card into the retainer,
ensuring that the bevelled corner (
06
) is
located bottom left and the gold contact
area is facing towards the gold contact
points inside the phone.
02
01
03
04
05
06
quickguide_en.book Page 7 Thursday, January 20, 2005 11:39 AM
