Vertiv™ XTE PTS Series PEIL/PESB Power Transfer Switches Description & Installation Manual
13
NOTE!
Mounting hardware is not provided. You must supply two 1/2-inch (1.27 cm) bolts suitable for the pole size.
3.
Dispose of the packaging according to local practices.
4.
Place the pole-mount channel in the mounting position on the pole.
5.
Use the pole-mount channel as a template to drill two mounting holes that will accommodate the two 1/2-inch (1.3 cm)
mounting bolts.
6.
Open the cabinet door.
7.
Remove the two 3/4-inch (1.9 cm) knockouts from the back of the cabinet. (See
Figure 8:
Pole-Mount Kit
8.
For each of the two bolts, slide one of the washer plates over one of the 1/2-inch (1.3 cm) mounting bolts and then slide one
of the rubber gaskets over the bolt.
9.
Install each bolt with its washer plate and gasket into the 3/4-inch (1.9 cm) knockout holes in the cabinet. (See Figure 8).
10.
Install the pole mount channel to the cabinet over the mounting bolts. (See
pole mount
channel
3/4-inch (1.9 cm)
knockouts
aluminum washer
plate
rubber gasket
solid bottom
rear view
