Vertiv SmartRow DCX, Руководство по установке

Страница: 21 / 74

The Vertiv SmartRow DCX Control Panel and Fire Suppression System should be field-connected as a separate zone to the
building fire detection and alarm system.
If the Vertiv SmartRow DCX is installed in a dedicated room, an additional strobe and horn may be installed at the entrance
to the room. Contact your local authorized service representative if required.
6.3 Vertiv™ SmartRow™ DCX Control Panel and Fire Suppression System Component
Locations
Figure 6.1 Vertiv SmartRow DCX Control Panel and Fire Suppression System, exterior features
Item Component Description
1
ALL DOORS
CLOSED indicator
Illuminates when all rack doors are closed.
2
FIRE
SUPPRESSION
SYSTEM ABORT
button
Prevents the fire-suppression system from dumping due to a false alarm.
3
DCX SYSTEM
EMERGENCY
POWER OFF
latching button
To engage the Emergency Power Off (EPO), press the button until it latches and the system shuts down.
To disengage the EPO, pull out the EPO button.
When engaged, all cooling units, UPSs (if wired into the EPO circuit), fire-suppression and emergency ventilation fans
power down. There are multiple ways to configure the EPO circuit per the electrical schematic to comply with local
codes, so your operation may vary. All equipment can be wired to shut down.
If equipped, the shunt trip breaker in the load panel can be wired to open as well.
4
FIRE
SUPPRESSION
MANUAL RELEASE
button
Turn the key to activate the manual fire-suppression release. If you see smoke and/or fire in the Vertiv™ SmartRow™
DCX system, but the smoke detector is malfunctioning, you can manually discharge the fire-suppression material into
the Vertiv SmartRow DCX system.
5 Horn and strobe Alarm sounds and strobe illuminates when the fire-suppression system is activated.
Vertiv | SmartRow™ DCX Installation Manual | 21