Vertiv Liebert MBX Busway, Инструкция по установке и эксплуатации, Страница: 5 / 16

1 INSTALLATION
Vertiv™ offers optional monitoring packages for the Liebert® MBX Busway System End Feed Box and Tap-
Off Box using Socomec DIRIS Digiware.
• End Feed Box Only Package: Includes DIRIS Digiware G-30, I-45 and U-30
• End Feed Box and Tap-Off Box Package: Includes DIRIS Digiware G-30, I-45, U-30, I-30 and C-31
interface module.
1.1 End Feed Box Monitoring Setup
NOTE: Before beginning to test or program any Digiware components in the Tap-Off Box, ensure that
your G-30 and U-30 Modules are configured.
For the G-30 Module ensure:
• All settings are set to default unless otherwise required by the client.
• Set the address to 1.
For the U-30 Module ensure:
• All settings are set to default unless otherwise required by the client.
• Set the address to 2.
NOTE: The addresses for the G-30 Module and the U-30 Module must not conflict.
NOTE: The G-30 must be programmed first, followed by the U-30, then any I-modules. The U-30
Module governs all I-modules’ baud rate and parity. Always check when testing I-modules that the
baud rate programmed into the U-30 carried over to the I-module.
1.2 End Feed Box Ethernet Configuration
1. Power ON the End Feed Box .
2. Connect the G-30 Module to your laptop using a standard straight through CAT5 ethernet cable.
3. Browse to www.Socomec.us, download and install the latest Easy Config software.
4. Click the Change Profile Button in the upper right corner of Easy Config.
5. Log in to the Super User profile using password "sOcOmec".
6. Click Add a Device.
7. Enter a Name for the End Feed Box.
8. Select
DIRIS G-30/G-40/G-50/G60 from the Type drop down menu.
9. Enter the IP address. The default address is 192.168.0.2.
10. Click Save .
11. Click Connect To Device .
12. Check the following settings:
a. Verify that the latest firmware is installed on the device. You can check the latest firmware
version on the "Socomec" website. If firmware needs updated, see Firmware Update on page 9 for
instructions.
b. Set the IP address and set the address (Slave ID) to 1.
1 Installation
1