Vertiv™ NetSure™ +24 VDC to -48 VDC Converter System Installation and User Manual
Proprietary and Confidential © 2022 Vertiv Group Corp.
24
5
Installing the Converter Modules and Initially Starting the
System
5.1
Installing Converter Modules
The converter module is hot swappable. It can be installed with the system operating.
ALERT!
To prevent damage to the latching mechanism, ensure the handle is in the open position when installing or
removing a converter module.
NEVER
hold the handle in the closed position when installing a converter module into a shelf.
Procedure
1.
Place the module into an unoccupied mounting slot without sliding it in completely.
2.
Loosen the captive screw on the module handle. Pull the handle to pivot it out of the module front panel (this will also retract
the latch mechanism located at the right side of the module). Refer to Figure 5.1 for latch mechanism illustration.
3.
Push the converter module completely into the shelf.
4.
Push the handle into the front panel of the module. This will lock the module securely to the shelf. Tighten the captive screw
on the handle.
5.
Repeat the above steps for each converter module being installed in the system.
6.
After the converter modules are physically installed in the mounting shelf(s), they are ready for operation immediately after
power is supplied to them.
Figure 5.1: Converter Module Handle/Latch Mechanism
Screw
Note: Handle must be
open when installing
or removing module.
Handle in
Closed Position
