Vertical WAVE IP 2500, Руководство по установке

Страница: 124 / 236

Power-cycling the Wave Server 7
-
12
Chapter 7: Initial Configuration
Wave Server Installation Guide
To add the Wave Server to your Windows domain:
12. If the Wave Server is not part of your Windows domain, on any tab click
Join Domain
to
add it. (To remove the Wave Server from your Windows domain, click
Leave Domain
.)
13. If you have no further changes to make, go to step 15.
To change the host name of the Wave Server:
14. On any tab, type the new name in the
Host Name
text box. The new name can be a
maximum of 15 alphanumeric characters and can contain hyphens (-).
To save your changes:
15. Click
Apply
and then click
Done
to save all of your changes. Note the following:
• If you changed IP network settings or configured the Wave Server for one-click
license activation, your changes take effect immediately. You do not need to restart
the Wave Server.
• If you changed the Wave Server’s Host Name, your change will not take effect until
the next time that the Wave Server is restarted.
16. If you are prompted to restart the Wave Server, do so.
Power-cycling the Wave Server
This section describes various shutdown and restart procedures.
Important:
Whenever you restart the Wave Server, be sure to close and restart browsers on
other PCs that had been running the Global Administrator to ensure that any upgrades or
changes that you applied are displayed correctly.
To restart the Wave Server (without powering off):
1. In the Global Administrator Management Console, choose
Restart System
in the General
Administration section.
2. In the Restart system dialog, specify how many seconds should elapse before the system
restarts.
3. Click
Restart
.
4. Click
Yes
at the confirmation screen, and then click
OK
to restart the Wave Server.
Release 4.0 June 20, 2013