Vertical WAVE IP 2500, Справочник по аппаратуре

Страница: 25 / 210

Compliance statements 1
-
9
Chapter 1: About This Guide
Wave Server Hardware Reference Guide
Industry Canada
This section describes the requirements for end users in accordance with CS-03.
The Industry Canada marking identifies certified equipment. This certification means that the
equipment meets certain telecommunications network protective, operational and safety
requirements as prescribed in the appropriate Terminal Equipment Technical Requirements
documents. The Department does not guarantee the equipment will operate to the user’s
satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the
facilities of the local telecommunications company. The equipment must also be installed using
an acceptable method of connection. The customer should be aware that compliance with the
above conditions may not prevent degradation of service in certain situations.
Repairs to certified equipment should be coordinated by a representative designated by the
supplier. Any repairs or alterations made by the user to this equipment, or equipment
malfunctions, may give the telecommunications company cause to request the user disconnect
the equipment.
Users should ensure for their own protection that the electrical ground connections of the power
utility, telephone lines, and internal metallic water pipe system, if present, are connected
together. This precaution may be particularly important in rural areas.
Users should not attempt to make such connections themselves, but should contact the
appropriate electric inspection authority, or electrician, as appropriate.
The Ringer Equivalence Number (REN) for each device (embedded processor, expansion card
or module) is listed in the table on page 1-7.
The standard connecting arrangement (telephone jack type) for each device (embedded
processor, expansion card or module) is listed in the table on page 1-7.
Release 2.0 Service Pack 1 April 2011