Vertex PWC-450, Руководство по обслуживанию

Страница: 19 / 27

PWC – 450
PureWaterCooler
Copyright 2011 Vertex Water Products
The sanitization procedure is performed to reduce/eliminate any bacteriological
growth in the cooler tanks and dispensing plumbing. Bacteriological growth
can be the cause of some taste and odor in the water.
The procedure is as follows:
1. Mix ½ Tsp. of common household bleach (5.25%) in 1 gallon of clean
water into a filter housing fixed with ¼” ports.
2. Unplug the cooler from the power source.
3. Drain all water from the cooler tanks.
4. Plumb the filter housing into the inlet water to the cooler.
5. Simultaneously press the hot and cold dispense buttons on the control panel.
6. When the mixture begins to flow from the spigot, release the hot dispense
button.
7. When the mixture begins to flow from the spigot again, release the cold
dispense button.
8. Let the sanitizing solution stand in the cooler for 10 minutes.
CAUTION: Leaving the sanitizing solution in the cooler for more
than 10 minutes can cause taste problems in the water.
9. While solution stands, disconnect the filter housing from the water line.
10. Drain the cooler completely.
11. Re-plumb fresh tap water to the cooler.
12. Fill the cooler completely with water. Let a few pints of water drain out of
the spigot while pressing the hot button and then the cold button.
13. Drain the cooler completely.
14. Repeat steps 12-13, 2-3 times.
15. The cooler is now sanitized and ready for normal use.
13. Sanitization Procedure