PWC – 600/2000
PureWaterCooler
Copyright 2004 Vertex Water Products
The sanitization procedure is performed to reduce/eliminate any bacteriological
growth in the cooler tanks and dispensing plumbing. Bacteriological growth
can be the cause of some taste in the water.
The procedure is as follows:
1.
Mix ½ teaspoon of common household bleach (5.25%) with 5 gallons of
clean water.
2.
Unplug the cooler from the power source.
3.
Drain all water from the cooler tanks.
4.
Pour the sanitizing solution into the main (room temperature) tank until full.
5.
Open all 3 spigots to allow sanitizing solution to fill the dispensing faucets.
Close the faucets.
6.
Let the sanitizing solution stand in the cooler for 10 minutes.
CAUTION: Leaving the sanitizing solution in the cooler for more
than 10 minutes can cause taste problems in the water.
7.
Completely drain the sanitizing solution from all the tanks.
8.
Fill the main (room temp.) tank with clear tap water to rinse out the
sanitizing solution.
9.
Completely empty the rinse water from the tanks.
10.
The cooler is now sanitized and ready for use.
12. Sanitization Procedure
