VX-1210
Alignment
3
Tune to:
Adjust or Confirm:
For:
“
VCO1 U
”
channel (8.9999 MHz, USB)
T2001
6.0 V
±
0.1 V
“
VCO1 L
”
channel (0.50000 MHz, USB)
Confirm
1.3 ~ 2.3 V
“
VCO2 U
”
channel (18.9999 MHz, USB)
T2002
6.0 V
±
0.1 V
“
VCO2 L
”
channel (9.00000 MHz, USB)
Confirm
1.0 ~ 2.0 V
“
VCO3 U
”
channel (30.00000 MHz, USB)
T2003
6.0 V
±
0.1 V
“
VCO3 L
”
channel (19.00000 MHz, USB)
Confirm
1.0 ~ 2.0 V
1st Local Output Level
r
Connect the RF millivoltmeter to TP1001 on MAIN Unit.
r
Confirm that the output level is 13 dBm
±
3 dB.
Receiver Alignment
RX IF Coils Alignment
r
Connect the RF Signal Generator to ANT jack, and connect the DC voltmeter to TP1005 on the
MAIN Unit.
r
Select the
“
RX IF
”
channel (10.15000 MHz, USB).
r
Inject a signal from the RF Signal Generator to 10.15100 MHz, then adjust the RF Signal
Generator output level so that the DC voltmeter reading is approximately 3 V.
r
Adjust T1008, T1009, T1010, T1011, T1012, T1015, T1016, and T1017 in succession several
times for minimum indication on the DC Voltmeter.
RX Gain Alignment
r
Connect the RF Signal Generator to ANT jack, and connect the DC voltmeter to TP1005 on the
MAIN Unit.
r
Select the
“
RX IF
”
channel (10.15000 MHz, USB), and recall the [RX GAIN] parameter on the
computer.
r
Inject a signal from the RF Signal Generator to 10.15100 MHz, then adjust the RF Signal
Generator output level for 6 dB
µ
.
r
Press the UP(
π
)/DOWN(
θ
) key so that the difference of the DC Voltmeter reading is 0.2 V
±
0.1
V when the RF Signal Generator on and off.
Noise Blanker Alignment
r
Connect the RF Signal Generator to ANT jack, and connect the DC voltmeter to TP1004 on the
MAIN Unit.
r
Select the
“
RX IF
”
channel (10.15000 MHz, USB).
r
Inject a signal from the RF Signal Generator to 10.15100 MHz, then adjust the RF Signal
Generator output level so that the DC voltmeter reading is approximately 3 V.
r
Adjust T1013 and T1014 for minimum indication on the DC Voltmeter.
47.055 MHz IF Trap Alignment
r
Connect the RF Signal Generator to ANT jack, and connect the DC voltmeter to TP1005 on the
MAIN Unit.
r
Select the
“
IF TRAP
”
channel (30.00000 MHz, USB).
r
Inject a signal from the RF Signal Generator to 47.05400 MHz, then adjust the RF Signal
Generator output level for 100 dB
µ
.
r
Adjust T1002 for maximum indication on the DC Voltmeter.
