VXA-210 P
ILOT
O
PERATING
M
ANUAL
45
1. Make sure that the transceiver is off. Remove
the hard or soft case, if used.
2. Remove the two screws affixing the belt clip and
remove the belt clip, then remove the battery pack.
3. Locate the connector for the
SU-1
under the
“Caution” label in the battery compartment on
the back of the radio, just carefully peel off the
“Caution” label.
4. Remove the small Rubber Cushion from the
“Caution” label. Keep this Rubber Cushion for
future use, because this Rubber Cushion must
be replaced on the connector board of the trans-
ceiver if you remove the
SU-1
from the trans-
ceiver. We recommend that this Rubber Cushion
be put on the bottom of the
SU-1
.
I
NSTALLATION
OF
THE
SU-1
Important Note
The Barometric pressure/Altitude feature of
the optional
SU-1
are designed to be supple-
mental aids for the information of the user, and
are not intended to be a substitute for accu-
rate, calibrated Barometer or Altimeter devices
used for navigation critical to personal safety.
5. Align the connector on the
SU-1
with the
transceiver’s connector and gently press the unit
into place.
6. Affix the “Caution” label, and replace the bat-
tery and the belt clip.
7. Installation is now complete.
MADE IN JAPAN
VERTEX STANDARD CO., LTD.
FCC ID:K66VXA-200
CANADA:
ÛÛÛÛÛÛÛÛÛ
ÛÛÛÛÛÛ
SER NO. 00000000
4909969000000
MADE IN JAPAN
VERTEX STANDARD CO., LTD.
FCC ID:K66VXA-200
CANADA:
ÛÛÛÛÛÛÛÛÛ
ÛÛÛÛÛÛ
SER NO. 00000000
4909969000000
MADE IN JAPAN
VERTEX STANDARD CO., LTD.
FCC ID:K66VXA-200
CANADA:
ÛÛÛÛÛÛÛÛÛ
ÛÛÛÛÛÛ
SER NO. 00000000
4909969000000
MADE IN JAPAN
VERTEX STANDARD CO., LTD.
FCC ID:K66VXA-200
CANADA:
ÛÛÛÛÛÛÛÛÛ
ÛÛÛÛÛÛ
SER NO. 00000000
4909969000000
Peel off the CAUTION Label
Press the
SU-1
Connector
Affix the CAUTION Label
Device restricted to occupational use to
satisfy FCC RF exposure compliance.
See owner's manual for specific operat-
ing requirement.
CAUTION
Device restricted to occupational use to
satisfy FCC RF exposure compliance.
See owner's manual for specific operat-
ing requirement.
CAUTION