FCC ID: K6630043X30
IC ID: 511B-30043X30
Alignment
Vertex Standard Co,. Ltd.
5
|DATA:xxx |
With
the
PTT
switch pressed, rotate the dial knob so that RF power is 25 W, then
press
CALL/SEL
key.
– Low Power Setting --
Connect the wattmeter and 50
Ω
dummy load to the antenna jack.
Press the
SCAN
key, then appear |ALIGNMENT |
on display.
|02:LO PO
|
|DATA:xxx |
With
the
PTT
switch pressed, rotate the dial knob so that RF power is 1 W, then press
CALL/SEL
key.
Then,
press
DISTRESS
key to enable the above settings.
Adjustment of Deviation
Adjust deviation in the transmit mode.
Setup the test equipment as shown below.
Set the output of the audio generator (AG) to 1 KHz and 100 mV.
Press the
SCAN
key, then appear |ALIGNMENT | on display.
|03:MAX DEV |
|DATA:xxx |
With
the
PTT
switch pressed, rotate the dial knob so that the maximum deviation is 4.2
kHz ±0.1 kHz, then press
CALL/SEL
key.
Confirmation of Transmit Power
Adjust power at high and low in the transmit mode, and confirm power in the specified
bandwidth.
Use
the
H/L
key to set transceiver to
high power
and set the channel to
CH16
. With
the
PTT
switch pressed, confirm that RF power is between 24 W ±0.5 W.
Use
the
H/L
key to set transceiver to
low power
. With the
PTT
switch pressed,
confirm that RF power is between 0.8 W ±0.1 W.
Use
the
H/L
key to set transceiver to
high power
and set the channel to
EXP01
. With
the
PTT
switch pressed, confirm that RF power is between 24 W ±1 W.
Use
the
H/L
key to set transceiver to
low power
. With the
PTT
switch pressed,
confirm that RF power is between 0.8 W ±0.2 W.
As descried above, confirm RF power at
EXP02
. Set transceiver to
high power
and
confirm that RF power is between 24 W ±1 W. Set transceiver to
low power
and
confirm that RF power is between 0.8 W ±0.2 W.
Confirmation of Deviation
Adjust deviation in the transmit mode.
Set the output of the AG to 1 kHz and 100 mV.
