IMPORTANT SAFETY INSTRUCTIONS
■
To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts,
cuts/abrasions and other hazards please read all warnings and instructions included and on the fixture box
and all fixture labels.
■
Before installing, servicing or performing routine maintenance upon this equipment, follow these general
precautions.
■
For Commercial Installation: Service and maintenance of this fixture should be performed by a qualified
licensed electrician.
■
For Residential Installation: If you are unsure about the installation or maintenance of this fixture, consult a
qualified licensed electrician.
Do not mount the unit against flammable surfaces.
The motion detector will not operate correctly if it is installed:
► Near the outlet of a central heating boiler
► Near an air conditioning unit
► Pointing directly at moving vehicles
► Within sight of reflection from moving water
► Where other lamps could shine on the sensor
■
Fixtures CANNOT be used with a dimmer switch, motion or occupancy sensor and other electronic switching
devices unless otherwise designated. LED fixtures must be powered directly off a switch circuit.
■
Do not install more than one motion sensor light on one wall switch.
■
This fixture should not be used in areas with limited ventilation or high ambient temperatures.
■
This fixture is intended to be connected to a properly installed and grounded.
■
These instructions do not claim to cover all details or variations in equipment or provide every possible
contingency to meet in connection with the installation, operation or maintenance. Should further
information be needed, you may contact Customer Service at
8
66-50
7
-505
7
.&,_
WARNING: RISK OF ELECTRICAL SHOCK
■
Turn off electrical power at fuse or circuit breaker box before wiring the VSL95 fixture to the power supply.
■
Verify that the supply voltage is correct. Connect fixture to a power source. (AC 100-240V 50/60Hz)
■
Make sure all electrical and grounded connections are in accordance with the National Electrical Code and
any applicable local code requirements.
■
All wiring connections should be capped with UL /CE listed connectors.
.&,_
CAUTION: RISK OF PRODUCT DAMAGE
■
Do not mount or support these fixtures in a manner that can cut the outer jacket or damage wire insulation.
■
Avoid covering LED fixtures with insulation, foam, or other material that will prevent convection or
conduction cooling.
■
Never connect an LED product directly to dimmer packs, occupancy sensors, timing devices or other related
control device unless individual product specifications deem otherwise.
■
Unless individual product deems otherwise, do not exceed fixtures maximum ambient temperatures.
■
LED products are Polarity Sensitive. Ensure proper polarity before installation.
■
Electrostatic Discharge (ESD) can cause damage to LED fixtures. Personal grounding equipment must be worn
during all installation or servicing of the unit.
■
Do not touch the individual electronic components, it may cause ESD, shorten lamp life or alter performance
.
.&,_
CAUTION: RISK OF INJURY
■
Wear gloves and safety glasses at all times when removing fixture from carton, installing, servicing or
performing maintenance.
■
Avoid direct eye exposure to the light source while it is on. Led lamps are extremely bright. Under no
circumstances should you stare into the Led light beam, this may cause irreparable damage to the eyes.
■
Account for small parts and destroy packaging materials, as these may be hazardous to children
.&,_
WARNING: RISK OF BURN
■
Allow fixture to cool before handling. Do not touch enclosure of light source.
■
Do not exceed the maximum wattage marked on the label.
■
Keep combustible and other materials that can burn away from the luminaries, fixture and lamp/lens.
---------1---------
Содержание VSL95
Страница 4: ......