5224 Bell Court
Chino, CA 91710
www.versatek.com
USA: 800-989-2797
Worldwide: 909-591-8891
Fax: 909-591-6962
Installation
SFP Transceiver Module: You can select different SFP modules as required (Please refer to our SFP selection
list for the appropriate module).
To insert/remove the SFP, the procedures are as follow:
1. On the side panel, insert the SFP
module into the SFP port until it is
securely locked.
2. Connect the optical fiber (1/2 core) to
the LC connector(s) of the SFP.
3. To remove the SFP module, press
down the lock of the LC connector of the
optical fiber to pull out the fiber cable.
4. Pull down the SFP lever and hold its
position. Pull out the SFP module from
the SFP port.
Setup
a) Connect the Ethernet port of the media converter to a PC or network device with a network cable.
b) Insert the appropriate SFP into the corresponding SFP port. Connect the fiber cable from the remote device (media
converter or switch) to the LC connector of the SFP.
c) After the device is powered on, the PWR indicator will all be on. If the indicators are not on, check the power supply
connection.
d) After all cables are correctly connected, the indicators will be lit as per port status LEDs (page 1).
