Tools needed:
Locate these parts:
Phillips Head
Screwdriver
HARDWARE BAG
A1
Hardware:
Assembly Step 4
1. Leave the cabinet upside down.
2. Position the burner chamber upside down
over the bottom of the cabinet as shown.
3. Set the burner chamber onto the bottom
of the cabinet, just inside the cut out
portion of the bottom panel.
4. Maneuver the burner chamber so that the
burner valve seats into the end of the
venturi tube.
5. Open the cabinet door to access the
burner chamber mounting holes.
6. From the inside of the cabinet, e
insert the 3
bolts into the mounting holes and
securely tighten.
nsure
that the mounting holes and mounting
tabs are properly aligned;
7. Locate the lose end of the ignitor wire routed
from inside the burner chamber. Connect the
wire to the unused prong on the back of the
ignitor module.
8. Turn the smoker assembly upright.
7
FRONT
Burner
Valve
Venturi
Tube
1/4-20 x 1/2”
Bolts
3 Required
Burner
Chamber
IMPORTANT!
The burner valve must be properly
seated into the venturi tube for safe operation.
