3
EN
Setup
The fourMulator was designed to work in modular synthesizer systems using the common eurorack format. Its
power supply, connectors and dimensions match the typical specifications (VERMONA Modular Case, Doepfer
A-100 and compatible systems). Installation is carried out just like for any module:
1.
Switch off the power supply! For safety reasons, also remove the detachable power cable from your frame
before mounting the module!
2. Connect the supplied ribbon-cable with its 10-pole connector to the corresponding multi-pin connector on
the fourMulator's rear. (see "Figure 1: fourMulator rear with connector" on page 4)
A
The corresponding plug socket is protected against reverse polarity. Therefore, the 10-
pole connector will only fit in one direction into the module. The supplied ribbon-cable is
color-coded at the -12 volts position. Note, that this may differ from other manufacturers.
Therefore, only use the supplied ribbon-cable to connect the fourMulator to your frame's
system bus!
3. Connect the ribbon-cable's 16-pole connector to an empty plug-socket of your frame's system bus.
Make
sure the color-coded side of the cable points towards -12 volts!
A
Connecting the ribbon-cable with reverse polarity can lead to damage of the fourMulator or
other modules when powering the system! Double check the connections before continuing
- safe is safe!
