Vermeiren Squod, Инструкция по эксплуатации

Страница: 14 / 32

Squod
2013-09
Page 12
2.6 Mounting or removing seat
L L L L
WARNING:
Risk of injury - Make sure that the seat is properly attached before
using the wheelchair.
To mount the seat to the
electric wheelchair:
1. Place the seat hooks
between the two bushings
, on each side.
2. Push the seat on the
backside downwards.
To remove the seat from the electric wheelchair:
1. Pull the front side of the seat
upwards, until the seat hooks come out the two
bushings .
2. Slide the seat to the front.
3. Lift the seat out the seat frame.
2.7 Mounting or removing arm support
L
L L
L
WARNING:
Risk of injury and/or damage - Make sure that the levers are
properly tightened before using the wheelchair.
L L L L
WARNING:
Risk of tipping over - Check that the armpads are at the same height
on each side.
L
L L
L
CAUTION:
Risk of clamping – Keep fingers, buckles and clothes away from the
attachment points of the arm supports.
The arm supports can be removed so the patient can be moved sideways. The arm supports
can also be removed for therapeutic purposes and to move the patient from the wheelchair.
To mount the arm supports on the electric wheelchair:
3. Mount the arm support in the rectangular tube .
4. Retighten the handle properly. (If the lever of handle
is not in a good position, press on button on the
handle and place the lever in a good position that no
risk of injury to the hands can appear.)
To remove the arm supports from the electric wheelchair:
4. Turn on the handle
until it come loose. (If the lever
of handle is not in a good position, press on button
on the handle and place the lever in a good
position that no risk of injury to the hands can appear.)
5. Remove the arm support out the rectangular tube .
The armpads are adjustable in different heights over a range of 90 mm (stepless) Keep a
safe distance from 10 mm on the bottom of the arm support.
1. Loosen the lever a little.
2. Move the rectangular tubes
and over each other until the desired armpad height.
3. Retighten the lever hand-tightened.
4. Check that the lever is securely attached.
5. Adjust the other armpad with the same instructions.