Vermeiren Eclips+ AD, Инструкция по эксплуатации

Страница: 17 / 120

EN
AD
2011-03
!"#$%&*%
3.3 Adjusting the seat height and seat angle
!
"
WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
!
"
WARNING:
Risk of tipping over - When the driving wheels are adjusted, the
position of the wheels are altered.
When adjusting the height of the seat the wheel may not touch the armrest. Maximum height
adjustment is when the wheel do not touch the armrest.
The Vermeiren AD is adjustable in 4 seat heights and different seat angles by
changing the wheels position. At each height there is a different setting of the front and rear
wheels.
The summary of the different seat heights by a standard seat angle 7° is tabulated below.
Seat height Rear wheel Front wheel
Ø Holes Ø
Adapter
!
/
fork
Holes
430 mm (16.93 in.) 22" Hole 9 and 11 200 mm Short Hole 2 and 3
470 mm (18.50 in.) 24" Hole 8 and 10 140 mm Standard Hole 2 and 3
500 mm (19.69 in.)
(Standard)
24" Hole 6 and 8 200 mm Standard Hole 2 and 3
530 mm (20.87 in.) 24" Hole 4 and 6 200 mm Standard Hole 1 and 2
Table 3: Seat heights AD
Change the seat height and seat angle according the following steps (refer to the figure on
the next page):
* Front wheel:
1. Loosen the screws
"
from the steering wheel adapter
!
.
2. Choose correct size for the adapter
!
and fork.
3. Place the steering wheel adapter in the desired position.
4. Tighten the screws " properly.
5. Change diameter of the steering wheel if necessary
(only for seat height 470 mm(18.5
in.)).
* Rear wheel:
6.
Remove the rear wheels (see § 2.13).
7. Loosen the fixing screws
"
from the rear axle block
!
.
8. Push the axle block
!
upwards or downwards to the desired height.
9. Tighten the screws
"
properly.
10. Mount the rear wheels.
11.
Adjust the brakes according § 3.8.