Vermeiren Comfort Chair, Руководство по обслуживанию, Страница: 5 / 16

Comfort chairs
2016-01
Page 3
1.2 Shipping and storage
The shipping and storage of the product shall be according following instructions:

Store in a dry place (b5 °C and +41 °C).

The relative humidity of the air should be between 30% and 70%.

Provide sufficient covering or packaging to protect the product from rust and foreign
bodies. (e.g. salt water, sea air, sand, dust).

Store all removed parts together in one place (or mark them if necessary) to avoid
mixing up with other products when re-assembling.

Components must be stored without being subjected to strains (Do not put too heavy
parts on the chair, not clamping between something, ...).
Only for electrical comfort chair:

Disconnect the power cable and carefully roll up the power cable with no kinks and
place it in the comfort chair.

Check internal cables for squashing and the prevention of kinks.
1.3 Care
1.3.1 Seat and backrest cushions
The cleaning of the seat and backrest cushions shall be according:

Clean seat and backrest cushions with a cloth moistened with hot water. Be aware
that you do not soak the seat and backrest cushions.

Use a mild commercial detergent for removing stubborn dirt. We shall decline all
liability for damage due to the use of improper cleaning detergents.

Stains can be removed by using a sponge or a soft brush.

Do not use strong cleaning liquids like solvents, nor use hard brushes or any other
pointed objects for cleaning.

Never clean with steam and/or pressure washers.
1.3.2 Plastic parts
Clean plastic parts of your comfort chair with commercial plastic cleaners. Only use a soft
brush or soft sponge. Please comply with special product information.
Examples of plastic parts are wheels.
1.3.3 Coating
The high quality of the surface layer guarantees optimal protection against corrosion. If the
outer coat is damaged by scratching or in some other way, get your specialist dealer to
repair the affected surface.
When cleaning, only use warm water and normal household detergents and soft brushes
and cloths. Ensure that no wetness gets into the tubes.
Initially the zinc parts only require rubbing with a dry cloth. Stubborn dirt can best be
removed by using a suitable commercial zinc polish.
1.3.4 Electronics (only for electrical comfort chair)
Before cleaning disconnect the power cable out the power socket.
Clean the electronic parts with a dry cloth.
Do not clean these in an automated washing system or high-pressure cleaner. Do not use
any abrasives or sharp-edged polishing equipment like a metal scrubber or brush, since
these can scratch the surface of the electronic parts. Do not use fluids that can penetrate in
the electronic parts. Do not use a cleaner that contains benzene, alcohol or similar solvents.