Vermeer 504 PRO, Руководство оператора и по техническому обслуживанию

Страница: 81 / 153

504PRO_604PRO_o-m2_00
-
7-18 Preparing the Equipment Baler 504/604 PRO Baler
7.7.1 Insert the Net
1. Push the new net roll (1) (see Figure 42 on page 7-19) into the holder.
2. Connect the safety chain (2).
3. Tilt the holder (3) and net into the net roll holder.
4. Turn the crank handle into the sleeve of the net roll up to the stop, and than 1/8 of a turn backward.
This ensures that the roll can rotate freely.
5. Make sure the crank handle should not go all the way to stop. There should be a gap between the inner washer(2) (see Figure 43 on page 7-
20) and the extruding bearing (1) of a distance of 3/8 – 1/2 ” (A). Overtightening will cause bearing failure or weld breakage.
6. Make sure the position of the spindles (1) and (2) (see Figure 44 on page 7-21) point in the center of the sleeve and not in the net. If necessary
loosen the spindle with the crank handle and repeat step 4.
7. Feed the net according to the picture from the net roll (1) (see Figure 45 on page 7-22) via roll 2, 3 and 4 to the rubber roll (5) and steel roll
(6).
8. Turn the rubber roll (5) by hand until the rolls grasp the net.
9. Make sure the net hangs out less than 10 cm beyond the rubber roll.
This prevents that the net is grasped into the baling chamber too early.
10.Remove the cotter pin and turn the bar (3) (see Figure 40 on page 7-16) of the net tightener to the front.
11.Remove the spring clip (3) and chain (2) (see Figure 39 on page 7-15) of the net knife safe guard (if applicable).
12.Close the top cover (2) (see Figure 40 on page 7-16) and side cover (1).
https://tractormanualz.com