8
First Steps
Verizon 200 / USA EN / A31008-M1929-R301-2-6019 / starting.fm / 9.6.08
Connecting the base station
¤
First
connect the power adapter and
then
the phone jack as shown below.
1 110-V power adapter
2 Back of the base station
3 Phone jack with phone cord
Please note:
u
The power adapter must
always be
connected
, as the phone will not oper-
ate without an electrical supply.
u
Your answer machine is set to give a
standard announcement.
Setting up the handset for use
Inserting the batteries
¤
Open the battery cover.
¤
Insert the batteries according to the
correct polarity (see diagram).
¤
Close the cover, and press the top so
that it clicks into place.
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at the same
height as the display.
¤
Press the belt clip onto the back of the
handset so that the protrusions on the
belt clip engage the notches.
Placing the handset in the base station
¤
Place the handset in the base station
with the handset's
display facing out-
wards
.
Charging the batteries for the first time
¤
To charge the batteries, leave the hand-
set in the base station or charging cra-
dle
continuously
for
ten
hours.
The alternately flashing battery icons
=
U
on the upper right side of the display
screen indicate that the batteries are
being charged.
Caution:
Use only rechargeable UL-approved AAA bat-
teries. Never use a conventional (non-
rechargeable) battery or other battery types as
this could result in significant health risks and
personal injury. For example, the batteries
could explode. The phone could also malfunc-
tion or be damaged as a result of using batter-
ies that are not of the recommended type.
Note:
If attached, remove the belt clip before open-
ing the battery cover.
1
2
3
