background image

T-Bolts

Flat 

Washers

Mounting 

Plate

Existing 

Table

Fender 

Washers

Hex Nuts

Flat 

Washers

Existing 

Table

Mounting 

Plate

Hex Bolts

T-Nuts

Drill-Press Table 

Caution:

 To use this product safely, 

always

 follow the safety 

instructions that came with your power tool. As with any power 

tool accessory, 

always

 wear eye protection and hearing protection.

Attaching Mounting Plate to Drill Press

Mounting hardware is supplied for drill-press tables with through slots and those 
with blind T-slots. 

Through Slots

1. Align  the 

3

/

4

"

  center  hole  in  the 

mounting plate with the center hole 
of existing table.

2. Insert T-bolts with flat washers in the 

recessed slots in the mounting plate 
and through slots in the table. 

3. Install fender washers and hex nuts, 

and finger tighten. 

4. Adjust mounting plate position on the 

table as needed. 

5. Tighten the four nuts. 

Blind T-Slots

1. Place a T-nut in each T-slot in the drill 

press-table such that they align with 
the slots in the mounting plate. This 
may involve some trial and error.

2. Align  the 

3

/

4

"

  center  hole  in  the 

mounting plate with the center hole 
of existing table.

3. Insert hex bolts with flat washers in 

the recessed slots in the mounting 
plate and into the T-nuts in the table. 

4. Finger tighten the bolts. 

5. Adjust mounting plate position on the 

table as needed. 

6. Tighten the four bolts. 

Отзывы: