VERITAS 9000A5, Руководство по эксплуатации

Страница: 13 / 60

Veritas 9000A5
Commissioning
11
Winding the bobbin thread
– Place the thread and the spool cap onto the spool pin. For smaller spools of thread, place the spool
cap with thesmall side next to the spool or use the small spool cap.
– Snap the thread into the thread guide.
– Wind the thread clockwise around the bobbin winder tension discs
– Place the thread end through one of the inner holes in the bobbin as illustrated and place the empty
bobbin on the spindle.
– Push the bobbin to the right
– When the bobbin winder spindle is pushed to the right, “winding position”, the symbol is shown
on the LCD screen. It will disappear from the LCD screen when the bobbin winder spindle is pushed
to the left into the “sewing position”
– Hold the thread tail securely and press on the foot control to start the sewing machine.
– Press the foot control so that the sewing machine starts winding
– After the bobbin has wound a few turns, stop the machine and cut the thread near the hole of the
bobbin. Continue filling the bobbin until it is full. The motor stops automatically when the bobbin is full.
Stop the sewing machine and cut the thread.
– Push the bobbin winder spindle to the left and remove.
Please note:
− When the bobbin winder switch is pushed to the right, “bobbin winding position”, the machine
will not sew and the handwheel will not turn. To start sewing, push the bobbin winder switch to
the left “sewing position”.
Winding the bobbin thread