Figure 5: Locating and locking the zero scale.
Middle graduation on
the zero scale
0
˚
graduation
0.5
°
0.25
Figure 6: Setting the fence angle.
3
The shooting board fence can be set accurately to within 0.25°.
Страница 1: ... the shooting board it may be necessary to periodically repeat these steps to maintain accurate results Adjusting the Track The first step is to set the track to fit your shooting plane Loosen the pan head screws that hold the rail in place Back the adjusting set screws off so that your plane can fit in the track To set a small amount of clearance place a piece of paper between the rail and the pl...
Страница 2: ...engaged in the detent plate so that the fence and plate move together Place an accurate square between the plane s sole and the fence Verify that there is no angular play between the fence and the detent plate when the spring plunger is bottomed out in the fence If there is use a screwdriver to adjust the spring plunger as shown in Figure 3a Tighten the outer two 8 screws the ones that only go thr...
Страница 3: ...Figure 5 Locating and locking the zero scale Middle graduation on the zero scale 0 graduation 0 5 0 25 0 Figure 6 Setting the fence angle 3 The shooting board fence can be set accurately to within 0 25 ...
Страница 4: ...ed above will need to be repeated periodically in order to maintain accurate results As noted above the sub fence is sacrificial and will eventually need to be replaced It can be made from quality 1 2 material preferably a softwood such as pine The 9 16 diameter countersinks should be such that the heads of the mounting screws are flush or recessed from the face of the sub fence The detents are pr...
