background image

Veritas Tools Inc.  Ottawa ON  K2H 1C2  Canada  veritastools.com
© Veritas Tools Inc. 2018 

606 INS-325_B

Install one of the mounting screws so that its top is just below the bottom of the blade, 
as shown in 

Figure 3

. Repeat for the second mounting screw, but move the adjustment 

mechanism in the opposite direction.

Slide the tote assembly (as shown in 

Figure 3

) under the blade until both projections 

on the tote arm register in the rear holes in the block plane body. Firmly tighten both 
mounting screws, skewing the blade as required for access. Retighten the lever cap 
wheel after the lateral adjust has been reset as required. 

If you wish to revert to using your low-angle block plane without the tote, reverse the 
procedure, but do not remove the mounting screws. They can be bottomed out in their 
holes, where they will safely remain and not loosen from vibration.

Tall Knob Installation

With the plane resting on a fl at surface, unscrew the brass front knob and replace it 
with the tall knob, as shown in 

Figure 4

.

Tote

Projection

Hole

Figure 3: Projections in tote arm are inserted into rear holes in block 
plane body.

Tall Knob

Brass Front

Knob

Toe

Figure 4: Installing the tall knob.

Отзывы: