VERIS INDUSTRIES
™
inStallation GUiDe
Ht SerieS
Z203269-0P
PAGE 2
©2010 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [email protected]
06101
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
installation
1. Remove the cover by pressing the tab at the top of the sensor while pulling
outward from the top of the cover.
5. Mount the backplate onto the wall using the screws provided.
6. Wire the backplate.
correct
incorrect
4. Position the sensor vertically on the wall, 4 1/2 feet above the floor.
Five screwholes available; use a
minimum of two for secure mounting.
2. Remove the backplate by unfastening the sensor from the bottom of the backplate
and pivoting the sensor outward.
3. Punch out openings in the backplate.
POWER SOURCE
15 to 30VDC or 24VAC
DIGITAL CONTROL
RH IN
Temp IN
RH setpoint IN
Temp setpoint IN
Thermistor/RTD IN
Thermistor/RTD IN
-
-
-
+
RH output
GND
Thermistor/RTD
Thermistor/RTD
Temp output
RH Setpoint output
Temp Setpoint output
7. Install and configure the sensor.
WARNING: Output select must be
correct before applying power.
RH
YES
AMP
VOLT
NO
YES
RUN CAL
NO
TEMP
–
Minus
Plus
Enter
+
RH
SENSOR
TEMP
SENSOR
RH
YES
AMP
VOLT
NO
YES
RUN
CA
L
NO
TEMP
–
Minus
Plus
Enter
+
RUN/CAL JUMPER:
CAL Mode - allows full access to all
features.
RUN Mode - allows access to relay
setpoints ONLY.
RH YES/NO JUMPER:
YES - allows user to change RH setpoint
NO - user can NOT change RH setpoint
TEMP YES/NO JUMPER:
YES - allows user to change TEMP
setpoint
NO - user can NOT change TEMP setpoint
8. Install the cover and snap into place.
