Verint nextiva s17xxe series, Руководство пользователя

Страница: 24 / 63

2: Configuring and Installing the Device
14 Verint Video Solutions
11. Select the unknown device, then click Configure . In the Reconfigure unit? confirmation
window, click Yes .
The New Network Configuration window appears.
12. To use DHCP (Dynamic Host Configuration Protocol), check Use DHCP . Otherwise,
enter the IP address, subnet mask, and gateway of the device, as provided by your
network administrator.
For more information about DHCP, see page 27.
13. Click OK .
The device reboots with its new network configuration. It may take up to 30 seconds.
14. In the Units tab, click Discover .
The new S17XXe device appears.
15. Select the device, then click Configure .
16. Configure the serial port parameters to match those of the target equipment (for
instance, camera or PTZ keyboard).
For more information, refer to the SConfigurator User Guide .
The S17XXe initial configuration is now complete. You perform further configuration with
either SConfigurator or a video management software from Verint Video Solutions.
Using the Encoders
On the S1704e-AS, S1708e, S1708e-AS, and S1712e, the composite video signal of an
input is sent to two separate encoders. You can have the following scenarios with regards to
the encoder use:
Scenario Encoder 1 Encoder 2
point-to-point point-to-point unused
video management software view at rate A record at rate B