Verilink WANsuite 5165, Справочное руководство

Страница: 176 / 235

4-52 W A N s u i t e 5 1 6 5
Summary Represents the past 24 hours; reports the additive number of frames/octets, the
highest peak encountered for 24 hours, and the average for 24 hours.
Current Reports on the current 15-minute interval.
Interval 1,
Interval 2,...,
Interval 96
Reports on Intervals 1-96, which correspond to the periods completed 15
minutes ago, 30 minutes ago,..., 24 hours ago.
SNMP Details Screen
The unit detects and reports T1 network alarms and provides several options
for reporting them, one of which is SNMP traps. When a network alarm
occurs, the unit sends a trap message to as many as eight destinations on your
network. The unit will report each alarm by transmitting an SNMP “trap” to
each non-zero Trap IP address.
The SNP Details screen (Figure 4.44) lets you configure the SNMP
parameters described in the following paragraphs.
Figure 4.44 SNMP Details Screen
Read Community Accepts a character string identifying the group authorized to perform read
operations. The default setting is “Public.”
Write Community Accepts a character string identifying the group authorized to perform write
operations. The default setting is “Private.”
Trap Community Accepts a character string, which is included in SNMP traps generated by the
unit. The default setting is “Public.”
Trap IP Address Accepts the IP address of a network device where alarm reporting traps are to
be sent.