8
6
Filling/Final measurement
When the mat has been laid as desired press the mat down against the floor to ensure optimal adhesion. Feed the power cable to the
thermostat connection point. Then cover the heating mat with a layer of flexible self levelling compound or flexible tile adhesive (fig. 9).
When subsequently laying a tiled floor on top the heating cable must simply be covered, whilst wooden floors, laminates, rugs, vinyl etc.
require a filling layer of at least 5 mm on top of the heating cable (fig. 10).
It is recommended that the self levelling compound or tile adhesive be left to harden in accordance with the manufacturer’s instructions
before the top floor is laid (tiles, wooden flooring, laminate etc.).
After fitting, measure the resistance value in the mat again (fig. 4a-4b). Use the same procedure as in section 2 – then make a note of the
values on the proof of warranty.
7
Finishing
After the work has been completed the floor must harden completely before the floor heating and thermostat are connected. This process
usually takes 8-10 days, but you should refer to the filler manufacturer’s guidelines. To connect the thermostat, please refer to the
thermostat installation guidelines.
Please note that Veria Quickmat must be supplied through a residual current device (RCD) having a rated residual operating
current not exceeding 30 mA.
Veria Quickmat can be used with the following thermostats:
Veria Control B35/45
Veria Control T45
Veria Control W35/45
Veria wish you all the best with your new heated floors!
12-year warranty for Veria Quickmat and Veria Flexicable
Veria’s products have been developed for many years of trouble-free use. Assuming that they are installed
correctly – according to the installation guidelines – we therefore provide a 12-year warranty on Veria
Quickmat and Veria Flexicable. A 2-year warranty is provided on other Veria products.
The warranty covers products that appear to be defective due to manufacturing, construction or material
faults.
However, the warranty is void if:
• The product has not been installed according to the installation guidelines
• It has not been connected by an authorised electrician
• The fault is caused by inappropriate/poor floor construction
The warranty is also conditional upon the accompanying proof of warranty having been filled in correctly. The proof of warranty must be
retained by the owner and must be produced in the event of a claim.
In the unlikely event that you have to make use of the warranty, we will repair the product or supply a new replacement product free of
charge. The warranty does not cover any indirect or additional costs such as costs relating to the localisation of the fault, removing the
product, repairing the floor etc.
In the event of a warranty claim the product will be sent to Veria – as agreed in advance - with a tracking label attached, stating the nature of
the fault. If our investigation shows that the product is not faulty it will be returned. If we find any faults Veria will return the repaired product
or supply a new Veria product and will take away the parts that have been removed or the faulty Veria product.
No additional claims may be made against Veria under the warranty.
years
12
Warranty
by Veria
