Product specifications – Veria Mirrorheat
Veria Mirrorheat is a heating foil used for keeping
your bathroom mirror mistfree.
To avoid damaging the mirror, it must be ensured
that the wall is solid and dry. Furthermore the mirror
should be fixed only on en even surface
Never affix anything on the mirror, that can prevent
the heat from being released.
Please comply with the following rules in order to ensure a safe and flawless use:
The cable wiring must be covered and inaccessible, and in compliance with local safety
standards and regulations.
The heating foil must be connected by an autorised electrician.
Stationary appliances without a means of all pole disconnection from the power supply
must have a disconnect device incorporated in the fixed wiring circuit.
Do not cut, pierce or fold the foil.
Metal parts surrounding the mirror must be earthed and comply with regulations.
Multiple foils fitted to a single mirror should be wired in parallel. Ensure that power supply
is sufficient to take the load. Do not overlap foils.
The power cable cannot be replaced. If the cable is damaged, the item should be
discarded.
The Veria Clickmat floor heating system is to be supplied through a residual current
device having a rated residual operating current not exceeding 30 mA.
Operating voltage:
230 V
Output:
See label
Output/m²:
200W/m²
IP class:
IP44
1. If the mirror is flush to the wall cut a recess in
the wall to house the terminal moulding.
2. Mark back of mirror where foil is to be fitted.
Ensure that mirror is clean and dry.
3. Peel off protective release paper.
4. Position one edge of the foil on the mirror back,
apply pressure evenly as the foil is gradually
lowered on to mirror back.
5. Connect the wiring to the lighting circuit or a
separate switch.
6. Re-attach mirror to the wall.
Installation guide – Veria Mirrorheat
[English]
[English]
