Verathon BLADDERSCAN BVI 6400, Руководство по эксплуатации и техническому обслуживанию, Страница: 19 / 48

13
Operations & Maintenance Manual: Setting up
SETTING UP
To help you get up and running as quickly as possible, the next few pages explain how to:
1. Perform Initial Inspection
2. Charge the Device
3. Activate the Device (Optional)
4. Install Scan Point Software (Optional)
PROCEdURE 1. PERFORM INITIAL INSPECTION
When you receive the device, Verathon ® recommends that there is a full visual inspection of the system for
any obvious physical damage that may have occurred during shipment.
1. Verify that you have received the appropriate components for your system by referring to System
Components & Accessories.
2. Inspect the components for damage.
3. If any of the components are missing or damaged, notify the carrier and Verathon Customer Care or your
local representative.
PROCEdURE 2. CHARGE THE dEVICE
In order to maintain electrical safety, use only the provided power adapter, battery, and battery
charger.
WARNING
The charging cradle, power adapter, and power cords are not intended for patient contact.
Ensure 2 m (6 ft) is maintained between the patient and these components.
WARNING
Before using your device for the first time, or when the battery becomes completely discharged, you must
charge your device battery for approximately 6 hours or until it is fully charged. In this procedure, you set up
the charging cradle and use it to charge the battery.
Note: If you have already installed Scan Point ® on your computer and installed the docking station, then you
can use the docking station to charge the device.
When you are not using your device, Verathon recommends that you store it in the charging cradle in order
to ensure that the device is always sufficiently charged. The charging cradle cannot overcharge the battery.