INSTALLATION MANUAL
ROLLER SHUTTERS
1771-190826EN
7
Subject to misprints, errors and technical modifications.
1. Disassemble the front cover of the box.
1.8 Fixating the box to the wall (optional )
Especially for larger dimensions it is advisable to fixate the sidecovers to the wall. This creates a better connection and
the legs of the sidecover are less burdened by the pantser weight.
2. Drill two mounting holes through the sidecover in the wall with a masonry drill.
Fixate the sidecover against the wall with 2 screws. Use screws, matching plugs and rings of a good quality.
1.9 Finishing touch mounting outside
1. Remove the last foil on top of the box and the guides.
2. Close the holes with the protection caps.
3.
Place, when needed, the end caps on the bottom of the guides (view figure on page 1). The end caps may NOT be
placed when the roller shutter closes on the windowsill or the ground/floor. In that case there will be an opening
of 4 mm when closing the roller shutter.
4. Lute the top and sides of the box.
Electrical control: for the prevention of water dripping inside.
Manual control: for prevention of dirt and moisture on the power cord.
Transparent lute gives the best result.
