Venue Lighting Effects revolver laser, Руководство пользователя

Страница: 13 / 24

13
www.venuelightingeffects.com
While an automatic program is enabled, you can choose whether or not to use the built-in microphone for
sound-active response. This option is accessed via the Control Display (page 6).
1. Press <MENU> until “SoUn” appears on the LED screen.
2. Press <ENTER> .
3. Using <UP> and <DOWN> , select either “on” or “oFF” to enable or disable sound-active mode.
4. Press <ENTER> to confirm settings.
5. Press <MENU> until “Auto” appears on the LED screen.
6. Using <UP> and <DOWN> , select “off” to allow sound active movement, or “on” to enable
quick auto movement sequences.
7. Press <ENTER> to confirm settings.
Sound-Active
While in sound active mode, you can adjust the sensitivity of the microphone via the
Control Display (page 6).
1. Activate a sound-active program (SoUn – ON).
2. Press
<MENU> until “SENS” appears on the LED screen .
3. Press <ENTER> .
4. Press <UP> or <DOWN> to adjust the sensitivity between 0 and 100
(0 = least sensitive, 100 = most sensitive)
5. Press <ENTER> to save your sensitivity setting.
Audio Sensitivity
This fixture has the ability to accept custom static color settings, as well as alter the dimmer, strobe, and
pan/tilt angle through the main menu. These are accessed via the Control Display (page 6).
1. Press <MENU> until “NAnu” appears on the LED screen.
2. Press <ENTER> .
3. Using <UP> and <DOWN> , select the color or parameter you would like to adjust.
4. Press <ENTER> .
5. Using <UP> and <DOWN> , select the desired value (0 - 255). By selecting 0 for a color parameter, that
color will remain off.
6. Press <ENTER> .
7. Repeat steps 3 - 6 until the desired color and position is obtained. The current setting will remain active
until <MENU> is pressed again, at which point the unit will revert back to its most recent program.
Custom Static Colors / Manual Control
The colors are represented by the following in the menu map:
Red1 = Moonflower Red (0 – 255)
Gee1 = Moonflower Green (0 – 255)
bLu1 = Moonflower White (0 – 255)
Uhl1 = Moonflower White (0 – 255)
Led2 = Laser (0 – 255)
DMX OPERATION
This is the operating mode which will allow for an external DMX controller. You must set the starting address
for this mode. If this is your first time using DMX, then it is recommended that you refer to the “DMX Primer”
section in the “Appendix” of this manual.
1. Press <MENU> until “ChNd” appears on the LED screen
2. Using <UP> and <DOWN> , select either “11-CH”, “13-CH”, or “17-CH”.
3. Press
<ENTER>
.