VENCO VENTURO INDUSTRIES LLC
CINCINNATI, OHIO
C200
MAN. OVERRIDE INSTR.
ET25/30/36KXP
09-16-19
DATE
SECTION
SUPERSEDES
TITLE
-
24415
MANUAL OVERRIDE INSTRUCTIONS
ET PROPRTIONAL SERIES CRANES
! ! R E A D A L L I N S T R U C T I O N S B E F O R E P E R F O R M I N G M A N U A L O V E R R I D E P R O C E D U R E S ! !
Each valve station incorporates [2] hydraulic ports and [2] coils. Manual
override shafts are located in the center of the coils (see figure 4).
Manual override decals are placed on each crane near the valve assembly.
These decals provide a visual aid that helps the operator determine the function
designations (Reference figure 3 & 5).
3-STATION FUNCTIONS:
RR
=
Rot. Right
RL
=
Rot. Left
BU
=
Boom Up
BD
=
Boom Down
BI
=
Boom In
BO
=
Boom Out
21988
ALWAYS BE SURE TO CHECK HYDRAULIC OIL LEVEL BEFORE PROCEEDING. IT IS RECOMMENDED TO
REMOVE ANY ITEM(S) THAT MAY INTERFERE WITH OPERATING THE CRANE MANUALLY. IF POSSIBLE,
STRAPS AND/OR HARNESSES SHOULD BE REMOVED BEFORE OPERATING A CRANE IN MANUAL OVERRIDE !!
4
5
6
Procedure:
1.
Turn Master disconnect switch to "ON"
2.
Remove Protective cap (see figure 1)
3.
Rotate Valve Stem Clockwise to close (see figure 2)
4.
Power up the pendant / radio
4.1.
Twist EMERGENCY STOP button clockwise
5.
On the crane, reference the function you wish to perform using the manual override decal (see
figure 3)
6.
Using a tool with a diameter of 1/8" or smaller, press the shaft inward and hold
7.
Reference the functions listed on your pendant or radio (see figure 6)
8.
Press the switch or button for the same function
9.
If you need to change function,
9.1.
Release switch or button
9.2.
Remove tool from shaft
9.3.
Go to step 5
For assistance, please feel free to contact Technical Support at 800-226-2238.
COIL
PORT
SHAFT
PROPORTIONAL COIL: MANUAL
OVERRIDE WITH GUARD
1
2
UP
OUT
UP
RIGHT
DOWN
IN
DOWN
LEFT
EXTENSION
WINCH
ELEVATION
ROTATION
P O
W
E R
E
M
E
R
G
E N C Y
S
T
O
P
HORN
UP
OUT
UP
RIGHT
DOWN
IN
DOWN
LEFT
BOOM
WINCH
BOOM
ROTATE
HORN
S
T
N
E
P
O
Y
C
G
R
E
M
E
P
O
T
S
Y
C
N
E
G
R
E
M
E
BATT
POWER
22158
23188
OVERRIDE
NORMAL
PROPORTIONAL
VALVE
ROTATE STEM
KEEP VALVE IN NORMAL POSITION.
OVERRIDE POSITION IS INTENDED
FOR EMERGENCY USE ONLY.
WARNING!
19315-2 Rev B
Protective Cap
23188
23188
THIS MACHINE IS NOT INSULATED
ELECTROCUTION HAZARD
MAINTAIN SAFE CLEARANCES FROM ELECTRICAL
LINES AND APPARATUS. YOU MUST ALLOW FOR
BOOM SWAY, ROCK OR SAG, AND ELECTRICAL
LINE AND LOAD LINE SWAYING.
THIS LIFTING DEVICE DOES NOT PROVIDE PRO-
TECTION FROM CONTACT WITH OR PROXIMITY
TO AN ELECTRICALLY CHARGED CONDUCTOR.
YOU MUST MAINTAIN A CLEARANCE OR AT LEAST 10
FEET BETWEEN ANY PART OF THE CRANE, LOAD
LINE OR LOAD, AND ANY ELECTRICAL LINE OR
APPARATUS CARRYING UP TO 50,000 VOLTS. ONE
FOOT ADDITIONAL CLEARANCE IS REQUIRED FOR
EVERY ADDITIONAL 30,000 VOLTS OR LESS.
DEATH OR SERIOUS INJURY
WILL RESULT FROM
CONTACT OR INADEQUATE CLEARANCE.
15392-E
DANGER
!
T HIS CR A NE IS N OT A PASSEN GER LIF T
IT IS NOT DESIGNED OR INTENDED TO BE USED TO LIFT,
SUPPORT OR OTHERWISE TRANSPORT PERSONNEL.
YOU MUST NOT
OPERATE THIS CRANE UNLESS:
1.
YOU HAVE BEEN TRAINED IN THE SAFE
OPERATION OF THIS CRANE; AND
2.
YOU KNOW AND FOLLOW THE SAFETY AND
OPERATING RECOMMENDATIONS CONTAINED IN
THE MANUFACTURER'S MANUALS, YOUR
EMPLOYER'S WORK RULES, AND APPLICABLE
GOVERNMENT REGULATIONS.
AN UNTRAINED OPERATOR SUBJECTS HIMSELF
AND OTHERS TO
DEATH OR SERIOUS INJURY .
15391-D
15390-D
!
CAUTION
1. INSPECT VEHICLE AND CRANE INCLUDING
OPERATION, PRIOR TO USE DAILY.
2. DO NOT USE THIS EQUIPMENT EXCEPT ON
SOLID, LEVEL SURFACE WITH CRANE
MOUNTED ON FACTORY-RECOMMENDED
TRUCK.
3. BEFORE OPERATING THE CRANE, REFER TO
MAXIMUM LOAD (CAPACITY) CHART ON CRANE
FOR OPERATING (LOAD) LIMITATIONS.
4. DO NOT OPERATE, WALK, OR STAND BENEATH
BOOM OR A SUSPENDED LOAD.
5. UNPLUG PENDANT AND SHUT OFF MASTER
DISCONNECT SWITCH WHEN CRANE NOT IN
USE.
6. FOR TRAVEL, BOOM MUST BE IN STOWED
POSITION.
OVERRIDE
NORMAL
PROPORTIONAL
VALVE
ROTATE STEM
KEEP VALVE IN NORMAL POSITION.
OVERRIDE POSITION IS INTENDED
FOR EMERGENCY USE ONLY.
WARNING!
19315-2 Rev B
3
Содержание ET36KXX
