Installation Instructions
1:
Disconnect power from the luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance.
2:
Remove the existing luminaire (if present) and dispose of per local requirements.
3:
Default CCT
–
5000K
; Default Wattage -
Highest
.
4:
Use selector switch to choose CCT and Wattage setting. (Figure 1)
5:
Attach safety cable to screw hole on fixture. Once fixture installation is complete, connect other end of cable to
ceiling or mounting surface
.
Installation Instructions
–
Suspension Mount
6:
Attach chain or cable to eye-bolt on top of fixture. (Figure 2)
7:
Attach chain or cable to ceiling structure.
8:
Connect the supply wires to junction box, or similar, as shown in wiring diagram below.
NOTE:
The correct polarity of the dimming connections is essential to proper operation.
NOTE:
If not using the dimming functionality, insulate the Dim(+) (purple) and Dim(-) (pink) wires separately (bare wires should not be left exposed).
DO
NOT
connect the Driver Dim(+) (purple) to the Driver Dim(-) (pink) wire as the fixture will not operate correctly.
9:
Power can now be restored to the system.
Installation Instructions
–
Surface Mount
6:
Remove hole plugs from 4 screw holes on fixture heatsink. Use bracket as a guide to determine which plugs to remove.
7:
Attach fixture to Surface Bracket by utilizing the provided mounting hardware.
8:
Surface kit is supplied with anchors. Drill (2) 10mm holes in ceiling. Use bracket as template.
9:
Use hammer to pound supplied anchors into holes. (Figure 3)
10:
Attach surface bracket to anchors and tighten nuts. (Figure 4 & 5)
11:
Set fixture to proper angle and tighten angle adjustment screws. (Figure 6)
12:
Connect the supply wires to junction box, or similar, as shown in wiring diagram below.
NOTE:
The correct polarity of the dimming connections is essential to proper operation.
NOTE:
If not using the dimming functionality, insulate the Dim(+) (purple) and Dim(-) (pink) wires separately (bare wires should not be left exposed).
DO
NOT
connect the Driver Dim(+) (purple) to the Driver Dim(-) (pink) wire as the fixture will not operate correctly.
13:
Power can now be restored to the system.
Figure 1
Figure 2
Figure 4
Figure 5
Figure 6
Figure 3
