Vents TwinFresh Comfo RA-35, Руководство пользователя, Страница: 16 / 24

www.ventilation-system.com 16
TwinFresh Comfo
CONNECTION OF SEVERAL VENTILATORS IN SERIES
TWINFRESH COMFO SA-35
TWINFRESH COMFO SA-35-2
TWINFRESH COMFO SA1-35
TWINFRESH COMFO SA1-35-2
TWINFRESH COMFO RA-35
TWINFRESH COMFO RA-35-2
TWINFRESH COMFO RA1-35
TWINFRESH COMFO RA1-35-2
TWINFRESH COMFO RA-50
TWINFRESH COMFO RA-50-2
TWINFRESH COMFO RA1-50
TWINFRESH COMFO RA1-50-2
TWINFRESH COMFO RA-85
TWINFRESH COMFO RA-85-2
TWINFRESH COMFO RA1-85
TWINFRESH COMFO RA1-85-2
Connection of the ventilators in series enables controlling all the connected ventilators by the first ventilator and the common remote control. To
connect the ventilators in series connect the Output contact socket of the first ventilator mounting plate with the Input contact socket of the second
ventilator mounting plate. Connect the second ventilator with the third ventilator in the same way, etc. Maximum 10 ventilators may be connected
in series. For easy electric installation use a five-wire cable (not included into the delivery set) with the cable cross section not below 0.5 mm
2 . The
cable must be rated for operation in an alternating current power supply with the country-specific mains voltage.
Disconnect the power cable while connecting the second, third, etc. ventilator in series.
The first ventilator controls all the connected ventilators.
The jumper between the contacts 1 and 2 or 2 and 3 of the CN7 socket connector determines a flow direction in
Ventilation mode.
•
If the jumper connects the contacts 1 and 2, air is extracted from the room in the
Ventilation mode
(factory
setting).
•
If the jumper connects the contacts 2 and 3, air is supplied in the
Ventilation mode
.
The jumper position at each ventilator connected in series determines a rotation direction in
Ventilation mode
and an operating phase in
Regeneration mode
.
I.e. if the jumper at the first ventilator connects the contacts 2 and 3 and the jumper at the second ventilator
connects the contacts 1 and 2, the ventilators operate in opposite directions in
Regeneration mode
.
CONNECTION OF SEVERAL VENTILATORS IN SERIES (BACKSIDE VIEW)
Input
L
G
-
D
N
Output
L
G
-
D
N
Input
L
G
-
D
N
L
G
-
D
N
ground
terminal
Ventilator no.2 Ventilator no.1
Output
L
G
-
D
N
Input
L
G
-
D
N
Input
L
G
-
D
N
Output
L
G
-
D
N
ground
terminal
ground
terminal
ground
terminal
1~100-240
V/50 (60) Hz
TO THE NEXT
VENTILATOR
Output
L
N
G
D
+
+
N
L
N
G
D
+
+
N
TB2
CN7
1
2
3
4
5
6
Ventilator
controller