Vents Simple 100, Руководство пользователя

Страница: 7 / 20

7
EN
DESIGNATION KEY
Vents 100 Simple X Х X
Motor and impeller modifications:
L — motor on ball bearings
Turbo — high-powered motor
12 — motor with 12 V/50 Hz rated voltage
K — backdraft damper
Additional options:
V — built-in pull-cord switch
T — turn-off delay timer
T1 — turn-on and turn-off delay timer
TH — humidity sensor and turn-off delay timer
Fan series
Outlet duct diameter [mm]
INSTALLATION AND SETUP
The fan is designed for wall or ceiling mounting with direct air exhaust to the ventilation shaft or into the round air duct of
matching diameter (Fig. 2).
Fan installation sequence:
Step 1. Cut off power supply and make sure electricity has been turned off (Fig. 4).
Step 2. Run the power cable to the vent hole (Fig. 5).
Step 3. Remove the front panel from the fan. Then remove the terminal block cover (Fig. 6).
Step 4. Mark and drill holes for mounting the fan and then install the fan (Fig. 7-9).
Step 5. Connect the fan to power mains according to the wiring diagram (Fig. 13-16).
Step 6. Install the terminal block cover (Fig. 10) and the front panel on the fan casing (Fig. 11).
Step 7. Supply power voltage to the fan (Fig. 12).