SERVICE
Service - 19
Storage
Preparing the Stump Grinder for Storage
1. Clean or wash the stump grinder to remove
accumulated wood chips, debris, and dirt.
2. Inspect for loose or missing hardware, damaged
components, or signs of wear. Repair or replace
any damaged or worn components.
3. Inspect safety decals. Replace any decals that
are faded, illegible, or missing.
4. Inspect belts for signs of damage or wear and
replace as required.
5. Inspect cutting teeth for wear and rotate, sharpen,
or replace the teeth as necessary.
6. Service all lubrication points and inspect gearbox
oil level. Wipe off excess grease or oil.
Removing the Stump Grinder from Storage
1. Clean the stump grinder to remove any accumu-
lated dust or debris.
2. Inspect the stump grinder as instructed in the
daily inspection section of this manual.
3. Test the stump grinder to ensure all components
are working properly.
Содержание KC180
Страница 22: ...Illustrated Parts 22 Use only original Ventrac replacement parts PARTS ILLUSTRATED DRAWING Main Frame Shields ...
Страница 24: ...PARTS Illustrated Parts 24 Use only original Ventrac replacement parts ILLUSTRATED DRAWING Drive Pulleys ...
Страница 26: ...PARTS Illustrated Parts 26 Use only original Ventrac replacement parts ILLUSTRATED DRAWING Mirror Bracket ...
