Vento zipr3i, Руководство по обслуживанию

Страница: 19 / 85

Rev no.01/ page 19of 128
TIRE
Inspect at initially 1000Kms 630 miles 2 months and
every 6000KM 3780 miles 12 months thereafter
Tire pressure
If the tire pressure is too high, the steering will be
Adversely affected and tire wear increased. Conversely, if tire
pressure is too low, stability will be adversely affected.
Therefore, maintain the correct tire pressure for good
Drivability and to prolong tire life.
CAUTION:
The standard tire fitted on the scooter is 3.50-10 for front and rear
The use of other Than standard may cause handling instability. It is highly
recommended to use genuine tire.
Tire treads condition
Operating the scooter with the excessively worn tires will decrease
riding stability and consequently invite dangerous situation. It is highly
Recommended to replace the tire when the remaining depth of tire tread
reaches the following specification.
Tire Tread depth limit: 1.6 mm 0.064 Inch
Use Tire depth gauge
STEERING
Inspect at initially 1000 kms 630 miles 2
months and every 6000 kms (3780 miles)
thereafter.
Steering should be adjusted properly for smooth turning of handlebars
and safe running. Over tight steering prevents smooth turning
of handlebars and too loose steering will cause poor stability.
Check that there is no play in the front fork assembly by supporting the
machine so that the front wheel is off the ground, with wheel straight
ahead, grasp lower shock absorber near the axle and pull forward. If play is
found, perform steering bearing adjustment.